|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
Bulletin PD-20046 rev. C 07/02 89CNQ...A Series SCHOTTKY RECTIFIER New GenIII D-61 Package Major Ratings and Characteristics Characteristics IF(AV) Rectangular waveform VRRM IFSM @ tp = 5 s sine VF TJ @ 40 Apk, TJ= 125 C (per leg) range 80 Amp Description/Features The 89CNQ...A center tap Schottky rectifier module has been optimized for very low forward voltage drop, with moderate leakage. The proprietary barrier technology allows for reliable operation up to 175C junction temperature. Typical applications are in switching power supplies, converters, free wheeling diodes, and reverse battery protection. 175 C TJ operation Center tap module High purity, high temperature epoxy encapsulation for enhanced mechanical strength and moisture resistance Low forward voltage drop 89CNQ...A Units 80 135 to 150 4300 0.69 A V A V - 55 to 175 C High frequency operation Guard ring for enhanced ruggedness and long term reliability New fully transfer-mold low profile, small footprint, high current package Case Styles 89CNQ...A 89CNQ...ASM 89CNQ...ASL D61-8 www.irf.com D61-8-SM D61-8-SL 1 89CNQ...A Series Bulletin PD-20046 rev. C 07/02 Voltage Ratings Part number VR Max. DC Reverse Voltage (V) VRWM Max. Working Peak Reverse Voltage (V) 89CNQ135A 135 89CNQ150A 150 Absolute Maximum Ratings Parameters IF(AV) Max. Av.Forward Current (Per Leg) See Fig. 5 (Per Device) IFSM EAS IAR Max. Peak One Cycle Non-Repetitive Surge Current (Per Leg) See Fig. 7 Non-Repetitive Avalanche Energy (Per Leg) Repetitive Avalanche Current (Per Leg) 89CNQ Units 40 80 4300 500 9 1.0 A Conditions 50% duty cycle @ TC = 130C, rectangular wave form (Rated VR ) Following any rated load condition and with 10ms Sine or 6ms Rect. pulse rated Vr applied TJ = 25 C, IAS = 1 Amps, L = 18 mH Current decaying linearly to zero in 1 sec Frequency limited by TJ max. VA = 1.5 x VR typical 5s Sine or 3s Rect. pulse A mJ A Electrical Specifications Parameters VFM Max. Forward Voltage Drop (Per Leg) See Fig. 1 (1) 89CNQ Units 0.99 1.14 0.69 0.78 1.5 21 980 5.5 10000 V V V V mA mA pF nH V/ s @ 40A @ 80A @ 40A @ 80A Conditions TJ = 25 C TJ = 125 C VR = rated VR IRM CT LS Typical Reverse Leakage Current (Per Leg) See Fig. 2 (1) Max. Junction Capacitance (Per Leg) Typical Series Inductance (Per Leg) TJ = 25 C TJ = 125 C VR = 5VDC, (test signal range 100Khz to 1Mhz) 25C Measured lead to lead 5mm from package body dv/dt Max. Voltage Rate of Change (Rated VR) (1) Pulse Width < 300s, Duty Cycle <2% Thermal-Mechanical Specifications Parameters TJ Tstg Max. Junction Temperature Range Max. Storage Temperature Range 89CNQ Units -55 to 175 -55 to 175 0.85 0.42 0.30 7.8 (0.28) Min. Max. 40 (35) 58 (50) C C Conditions RthJC Max. Thermal Resistance Junction to Case (Per Leg) RthJC Max. Thermal Resistance Junction to Case (Per Package) RthCS Typical Thermal Resistance, Case to Heatsink (D61-8 Only) wt T Approximate Weight Mounting Torque (D61-8 Only) C/W DC operation C/W DC operation C/W Mounting surface , smooth and greased Device flatness < 5 mils g (oz.) Kg-cm (Ibf-in) 2 www.irf.com 89CNQ...A Series Bulletin PD-20046 rev. C 07/02 1000 1000 Tj = 175C 100 Reverse Current - IR (mA) 150C 10 1 125C 100C 75C 0.1 0.01 0.001 0 30 50C 25C Instantaneous Forward Current - I F (A) 100 60 90 120 150 Reverse Voltage - VR (V) T = 175C J Junction Capacitance - C T (p F) Fig. 2 - Typical Values Of Reverse Current Vs. Reverse Voltage (Per Leg) T = 125C J 10000 10 T = 25C J T = 25C J 1000 1 0 0.2 0.4 0.6 0.8 1 1.2 Forward Voltage Drop - VFM (V) 1.4 1.6 100 0 30 60 90 120 150 Reverse Voltage - VR (V) Fig. 3 - Typical Junction Capacitance Vs. Reverse Voltage (Per Leg) Fig. 1 - Max. Forward Voltage Drop Characteristics (Per Leg) 1 D = 0.75 D = 0.50 D = 0.33 D = 0.25 D = 0.20 0.1 Thermal Impedance Z thJC (C/W) PDM 0.01 Single Pulse (Thermal Resistance) Notes: 1. Duty factor D = t1/ t2 t1 t2 0.001 0.00001 2. Peak Tj = Pdm x ZthJC + Tc 0.0001 0.001 0.01 0.1 1 t1 , Rectangular Pulse Duration (Seconds) 10 100 Fig. 4 - Max. Thermal Impedance ZthJC Characteristics (Per Leg) www.irf.com 3 89CNQ...A Series Bulletin PD-20046 rev. C 07/02 180 Allowable Case Temperature (C) 170 160 150 140 130 120 Square wave (D = 0.50) Rated Vr applied DC 110 100 90 see note (2) 80 0 10 20 30 40 50 60 Average Forward Current - IF(AV) (A) Fig. 6 - Forward Power Loss Characteristics (Per Leg) Average Forward Current - IF(AV) (A) Fig. 5 - Max. Allowable Case Temperature Vs. Average Forward Current (Per Leg) Non-Repetitive Surge Current - I FSM (A) 10000 1000 At Any Rated Load Condition And With Rated Vrrm Applied Following Surge 100 10 100 1000 10000 Square Wave Pulse Duration - tp (microsec) Fig. 7 - Max. Non-Repetitive Surge Current (Per Leg) L HIGH-SPEED SWITCH FREE-WHEEL DIODE 40HFL40S02 Vd = 25 Volt DUT IRFP460 Rg = 25 ohm Average Power Loss (Watts) + CURRENT MONITOR Fig. 8 - Unclamped Inductive Test Circuit (2) Formula used: TC = TJ - (Pd + PdREV) x RthJC ; Pd = Forward Power Loss = IF(AV) x VFM @ (IF(AV) / D) (see Fig. 6); PdREV = Inverse Power Loss = VR1 x IR (1 - D); IR @ VR1 = Rated VR 4 www.irf.com 89CNQ...A Series Bulletin PD-20046 rev. C 07/02 Outline Table Outline D61-8 Dimensions are in millimeters and (inches) Outline D61-8-SM Dimensions are in millimeters and (inches) www.irf.com 5 89CNQ...A Series Bulletin PD-20046 rev. C 07/02 Outline Table Outline D61-8-SL Dimensions are in millimeters and (inches) 6 www.irf.com 89CNQ...A Series Bulletin PD-20046 rev. C 07/02 Part Marking Information INTERNATIONAL RECTIFIER LOGO THIS IS A 89CNQ150A WITH LOT CODE 89 09 ASSEMBLED ON WW 45, 2000 IN THE ASSEMBLY LINE "A" ASSEMBLY LOT CODE PART NUMBER 89CNQ150A 89 09 045A DATE CODE YEAR 0 = 2000 WEEK 45 LINE A D61-8 INTERNATIONAL RECTIFIER LOGO THIS IS A 89CNQ150ASM WITH LOT CODE 89 09 ASSEMBLED ON WW 45, 2000 IN THE ASSEMBLY LINE "A" ASSEMBLY LOT CODE 89CNQ150ASM 89 09 045A DATE CODE YEAR 0 = 2000 WEEK 45 LINE A PART NUMBER D61-8-SM INTERNATIONAL RECTIFIER LOGO 89CNQ150ASL 89 09 045A PART NUMBER THIS IS A 89CNQ150ASL WITH LOT CODE 89 09 ASSEMBLED ON WW 45, 2000 IN THE ASSEMBLY LINE "A" ASSEMBLY LOT CODE DATE CODE YEAR 0 = 2000 WEEK 45 LINE A D61-8-SL www.irf.com 7 89CNQ...A Series Bulletin PD-20046 rev. C 07/02 Data and specifications subject to change without notice. This product has been designed and qualified for Industrial Level. Qualification Standards can be found on IR's Web site. IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245, USA Tel: (310) 252-7105 TAC Fax: (310) 252-7309 Visit us at www.irf.com for sales contact information. 07/02 8 www.irf.com This datasheet has been download from: www..com Datasheets for electronics components. |
Price & Availability of 89CNQ135ASL |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |